M&S Auto

I had this vehicle Dodge Intrepid in my workshop which had been towed to my shopa problem with the engine not workingwhen I asked the owner told me the engine was shut down when it was runningtold him I was going to find out what had happened, after it was towed the car I started trying to find the problemAs a first step, I began to find it if I had gas in the system, which could be the fuel pump does not workWith a fuel pressure tester and I found that had the sufficient pressureThen a second step, I began to find out if there was spark with a spark tester in each of the ignition coils and spark enough having made the NEXT step take my scanner connect to the car, and found a code that came from the camshaft sensor and buy the sensor and install the car, but to install is sensor had to remove the intake manifold, which is under the intake manifold, but not having any success, as last step Remove the spark plugs of the number one cylinder and a compression tester making a discovery proves that he had no compression, so I started by removing all of the remaining cylinders spark plugs and doing the same test all cylinders had no compressions It was when the owner of the car said it was going to be towed back to the address given by customer to fix it to there And in doing all these test procedures the car battery died and with a battery charger, charge the battery but not charged and the starter by these tests I did stop working why change it

I had this vehicle 2001 Dodge Intrepid in my workshop which had been towed to my shop. a problem with the engine not working. when I asked the owner told me the engine was shut down when it was running. told him I was going to find out what had happened, after it was towed the car I started trying...

to find the problem. As a first step, I began to find it if I had gas in the system, which could be the fuel pump does not work. With a fuel pressure tester and I found that had the sufficient pressure. Then a second step, I began to find out if there was spark with a spark tester in each of the ignition coils and spark enough having made the NEXT step take my scanner connect to the car, and found a code that came from the camshaft sensor and buy the sensor and install the car, but to install is sensor had to remove the intake manifold, which is under the intake manifold, but not having any success, as last step Remove the spark plugs of the number one cylinder and a compression tester making a discovery proves that he had no compression, so I started by removing all of the remaining cylinders spark plugs and doing the same test all cylinders had no compressions It was when the owner of the car said it was going to be towed back to the address given by customer to fix it to there And in doing all these test procedures the car battery died and with a battery charger, charge the battery but not charged and the starter by these tests I did stop working why change it

Review: Had my 2001 dodge intrepid towed to his garage for repair because it stopped on the parkway with the engine light on. At that time the engine was clean, full of oil, battery fully charged, & starter worked. They had the car for one and a half days and could get it started.I had the car towed back to my address Milltown NJ when I opened the hood there were bolts missing from the intake manifold, the engine was covered in oil & was a quart low, the battery was dead, and when I tried to jump it the starter would not engage. The car is in worst condition than when I gave it to them.Desired Settlement: $100 refund for what I paid them, plus cost of towing back to Milltown NJ from Wildwood NJ $122 & cost of the damage they caused. Amount unknown at this time

Business

Response:

I had this vehicle 2001 Dodge Intrepid in my workshop which had been towed to my shop. a problem with the engine not working. when I asked the owner told me the engine was shut down when it was running. told him I was going to find out what had happened, after it was towed the car I started trying to find the problem. As a first step, I began to find it if I had gas in the system, which could be the fuel pump does not work. With a fuel pressure tester and I found that had the sufficient pressure. Then a second step, I began to find out if there was spark with a spark tester in each of the ignition coils and spark enough having made the NEXT step take my scanner connect to the car, and found a code that came from the camshaft sensor and buy the sensor and install the car, but to install is sensor had to remove the intake manifold, which is under the intake manifold, but not having any success, as last step Remove the spark plugs of the number one cylinder and a compression tester making a discovery proves that he had no compression, so I started by removing all of the remaining cylinders spark plugs and doing the same test all cylinders had no compressions It was when the owner of the car said it was going to be towed back to the address given by customer to fix it to there And in doing all these test procedures the car battery died and with a battery charger, charge the battery but not charged and the starter by these tests I did stop working why change it